Bit Driver and Handle V2

thingiverse

Sort of an update of a previous design of my own. This I ran with a PLU handle which slide comfortably over a PETG driver. I printed both at .4 res from a .8 nozzle from an otherwise stock Ender 3 Pro. PLA would no doubt work as well. If you print both parts in a hard filament consider printing the handle part at 101% or so. The driver part comes out a little tight on some of my bits. If possible put one of the bigger ones in as soon as it comes off the print bed or toss it in the oven around 175 degrees for ten to fifteen minutes then put in your favorite extension and pull it out to customize it exactly to your tools. I did not use supports for the handle. Even though the PLU doesn't bridge it very beautifully it figures it out.