Birdhouse with geometric pattern

thingiverse

Human: Supports highly recommended. I printed mine without, but the bottom and ceiling turned out a bit rough. Had to do a lot of cleanup, and pretty much drowned it in acetone to get it nice looking in the end. Turned out much better than I had dared hope though. Now I just hope the birds will like it as much as I do. Note: The two holes in the back of the top are for mounting a string. It's supposed to hang in a string, fastened three places - two on each side of the cage front top, and one in the rear holes. The five holes in the bottom allow rain to drain out. I think I pushed Tinkercad pretty close to its limit with this one - it was quite slow to work with in the end, and it took about 10 attempts to download the STL without getting hit by a "bad gateway" error. Print Settings Printer: Zortrax M200 Rafts: Yes Supports: Yes Resolution: 0.19mm Infill: Max Notes: I printed it without supports - trust me, it's better to add supports.