Bird House

myminifactory

I designed this birdhouse in Tinkercad and used a Prusa MK2s printer. The main house was printed in 3 draft mode, while the eaves and roof were resolved at 2 resolutions and the windows at 1.5 resolutions with a two-color print setup. The raft, too, was printed at 1.5 resolution. It stands about eight inches high and seven inches square. Holes are drilled into the eaves for hanging with rods that have loops on each end. I also added holes to the bottom for screwing onto a board or post, all possible thanks to a clean-out door in the back. So far, everyone who's tried this wants one. Thanks to those who've shared their thoughts and ideas!