Bird feeder

prusaprinters

Simple bird feeder using a 1.5 liter pet bottle. Intended to work with sunflower seeds. Post-Printing Cut the bottom and top of the pet bottle. The resulting hole in the top of the bottle should be approximately the size of the hole in the "feeding_tray_mount.stl" (the smaller diameter of the funnel part). Mount the "Feeding_tray.stl" by putting the "feeding_tray_mount.stl" into the bottle and screwing them together with an M3 screw. Use the handle mount to mark where you want the holes for the handle in the pet-bottle. Then make 3mm holes there. Thread the handle to the opening in the roof and connect it with the handle mount with two "washer.stl" and two M3 screws. Category: Outdoor & Garden