BIQU H2 Mount - Ender 3 and Ender 5 Compatible !

thingiverse

Hey guys, this is my remix for the Morninglion mount for the BIQU H2, from Morgan Lowe (thanks for this already very good design). I loved this mount, but it was not that easy to use a good cooling solution. I ended up remixing this file in Tinkercad to remove the front and bottom screw supports, thus making custom 5015/4010 ducts possible to install. The Biqu H2 is firmly held to the X carriage and does not wiggle at all. Installing the Eccentric wheel might be a bit tricky, but still possible. ------------------------------------------------------------------------------------------------------------------------ V2 Update : Now compatible with the Ender 5 ! Also adds holes for the cable management and a hole to fit the washer and bolt for the bottom wheel easier. ------------------------------------------------------------------------------------------------------------------------ Mounting tutorial: 1. Disassemble your old cooling system until you have a free X axis carriage. 2. Place the top right wheel screw into the hole. 3. Place the Biqu H2 and screw it to the four screw holes, starting by the bottom back one. Put each screw without screwing it all the way. Take time to place the fan wire (if it is on the top) in the small sleeves on the mount. 4. Screw all the screws all the way in. 5. Place the eccentric wheel bolt and washer on the printed support (in the hole). You can slide your wrench inbetween the Extruder and the mount, to hold the bolt in place. 6. Put the whole assembly back on your X axis extrusion, and put the top left wheel screw in the hole. 7. Put back the metal spacers and wheels, and tighten the wheel bolts (this part might be tricky too, so use your allen wrench to hold the screws while screwing the bolt on the other side. 8. Once the screws are tight, and the carriage is now on the X axis extrusion, adjust your eccentric nut. 9. Install/print any cooling system you want, if you need one. And voila ! You now have a solid Biqu H2 mount for the Ender 3, that does not use the stock cooling box screws (some carriage holes on some Enders are offset, and then make installing custom ducts or mounts impossible, so installing it by the wheel holes is way more secure and safe. Do not forget to adjust your X and Y offsets. X offset: 17mm Y offset: 21mm I hope you guys will have success using this remixed mount !