BIQU H2 Anycubic i3 Mega mount

prusaprinters

<p>Best to use ABS ASA or PETG.&nbsp;</p><figure class="media"><oembed url="https://www.youtube.com/watch?v=P08CmPWZfIg&amp;t=14s"></oembed></figure><p>perimeter 3, layer 0.2mm 15% infill.</p><p>After removing the old Hotend completely this slides on the bearings without loosing the rails again.</p><p>You can use the original hotend fan. As well i used the original heater and temperature sensor for the hotend. Normally the BIQU H2 is delivered with 24V fan and heater. so if want a matching fan you need to buy a 35mm fan for 12V.</p><p>The original duct fan is to weak for fast printing so i am using a radial fan 5015.</p><p>Two different Ducts. If you use a BLtouch you need the back mounted one.</p><p>The system is printing very reliable.</p><p>Additional parts</p><p>See photo</p><p>radial fan 5015</p><p>&nbsp;</p><p>If you just want to improve your Anycubic with standard Extruder see:</p><p><a href="https://www.prusaprinters.org/prints/60561-anycubic-big-fan-mount">https://www.prusaprinters.org/prints/60561-anycubic-big-fan-mount</a></p><p>Housing i use:</p><p><a href="https://www.prusaprinters.org/prints/47885-box-jellyfish-3d-printer-enclosure-ikea-lack-table">https://www.prusaprinters.org/prints/47885-box-jellyfish-3d-printer-enclosure-ikea-lack-table</a></p><p>&nbsp;</p>