BIQU H2 Anycubic Chiron Mount

thingiverse

***Update 2/21/2022 ***** I have uploaded a version of the linear rail system. You will find two new models. One is a Chiron Mounting plate that has been customized for mounting it to the MGN12C Linear rail on the x-axis. The other is a newly updated H2 Mount for this setup. Please note since you no longer use the wheel bolts for this, you will now mount the H2 plate to the Linear Rail plate using 3 m4 screws and nuts 6-8mm long screws should work fine. You will notice on the back of the Chiron plate there are 3 recessed holes for the m4 nuts. These are the new mounting point for the H2 plate. Additionally, you will need to recalibrate your machine and update the marlin software for the offset caused by the linear rails and the new mounting plate. These are some rough numbers to help you get close. Again I do not take responsibility for you changing hardware or the firmware on your printer. If you have questions feel free to ask. It is recommended to modify these values in configuration.h in the firmware to adjust the bed // Travel limits after homing (units are in mm) define X_MIN_POS -10 define Y_MIN_POS -15 define Z_MIN_POS 0 define X_MAX_POS 410 define Y_MAX_POS 395 define Z_MAX_POS 455 ****** End of Update ******** This is a remix of the ender 3 mounts. Instruction in Progress: I need to do an instruction with photography for mounting. Biqu H2 Mount + cover for Bl-Touch for AnyCubic Chiron It is a design that hide cables and have a nice finish. I will make an instruction to mount the cables behind the extruder. It is not really complicated to hide the cables. Motor connector must be going to the top. I used these fan ducts for part cooling: You can choose which you prefer. https://www.thingiverse.com/thing:4682915 https://www.thingiverse.com/thing:4757657 https://www.thingiverse.com/thing:4931226 https://www.thingiverse.com/thing:4915655 BL-Touch offsets: Design 1: X58 Y~0 Z~2.7 (need to calibrate for your printer z height for first layer this setting is set to this height to avoid any issue when first running the printer to set up the z-offsets.)