Biqu B1 BLTouch mount

prusaprinters

<p>The metal BLTouch mount included with the Biqu B1 was bent at an angle and couldn't easily be bent vertical, so I remixed this mount. It had too much adjustment for my needs, so I simplified the design which included by recesses to capture M3 nuts and an access hole for the adjustment screw.</p><p>Designed for and tested with a genuine BLTouch 3.1, so your mileage may vary if using a clone or a different version.</p><p>You will likely need to babystep your Z probe offset to suit your needs, but -1.5 is a good start.</p><h3>Probe Offsets</h3><p>Probe offsets are included in the filename, but they are also listed below:</p><h3>define NOZZLE_TO_PROBE_OFFSET { -1.5, -34, -1.5 }</h3><h3>BOM</h3><ul><li>1 x BLTouch 3.1</li><li>2 x M3 nyloc nuts</li><li>2 x M3 x 3mm or longer screws BLTouch Firmware</li></ul><p>You can find a base <a href="https://github.com/MarlinFirmware/Configurations/tree/import-2.0.x/config/examples/BIQU/B1-BLTouch">Biqu B1 BLTouch firmware in the Marlin Configurations repo</a>. Just adjust the probe offsets as mentioned above.</p><h3>Print Settings</h3><p><strong>Printer:</strong></p><p>Biqu B1</p><p>&nbsp;</p><p><strong>Rafts:&nbsp;</strong></p><p>No</p><p><strong>Supports:</strong></p><p>&nbsp;</p><p>No</p><p>&nbsp;</p><p><strong>Resolution:&nbsp;</strong></p><p>0.2</p><p><strong>Infill:</strong></p><p>&nbsp;</p><p>20%</p><p><strong>Filament:</strong> Generic PETG Black</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: 3D Printer Parts</p>