Biodogradable Dog Bag Dispenser

thingiverse

I use the Biodogradable brand of dog poop bags, which tends to run a bit larger than other brands, and also doesn't have the little tube "spool" in the middle. This means that most bag dispenser designs on Thingiverse don't fit these bags. This model should hold bags up to 70mm in height and approximately 42mm in diameter. I really liked bandslinger's design, but scaling it up resulted in super thick walls. The only part directly copied from bandslinger's version is the loop, with the "spike" shaved off, but you can clearly see that most of my design wound up being similar to that one. Note: I left a "ring" below the threads inside the cap on purpose, so you could add an o-ring if you have issues with the cap coming unscrewed. My previously printed dog bag holder had this issue, but so far this design seems like it stays screwed on its own. Time will tell if I end up needing that o-ring or not. Note: The ring is a pretty tight fit on my printer and doesn't even need glue to stay in place. You may need to scale it up or down slightly depending on your setup. I'm also using a 0.6mm nozzle, which may affect things like how sharp my corners are, but in general it shouldn't affect dimensional accuracy too much. Hopefully, it works without too much fiddling for most people.