Binary clock panel and firmware - full project
thingiverse
Hi, this is my simple project with binary clock. Used in it are Arduino mega 2560 and RTC DS1302. The program works perfectly well on an Arduino UNO (Atmega328P) too - tested! All you need to do is change the pin connection for UNO: RTC remains unchanged - myRTC(7, 6, 5); // CLK, DATA, RST Output pins for LEDs are assigned as follows: "LED 1" = pin 8; "LED 2" = pin 9; "LED 4" = pin 10; "LED 8" = pin 11; "LED 16" = pin 12; and "LED 32" = pin 13. Output pins for rows are unchanged - two green seconds, three yellow minutes, and four red hours. The HEX file for MCUs and DS1302 has been uploaded. 19.2.2019 - a new firmware was added for UNO, along with setup/down buttons on A0-A3 (connect Ax to GND). I wish you many fun experiences! https://www.youtube.com/watch?v=kkWC_v7ntn4
With this file you will be able to print Binary clock panel and firmware - full project with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Binary clock panel and firmware - full project.