Biltwell Lane Splitter GoPro mount

thingiverse

My first attempt at a 3D design - chin mount for GoPro on Biltwell Lane Splitter (size small) helmet. Printed upside-down on Creality CR-6 Max with PLA at 100% infill. However, I reckon it should be fine at a lower percentage. Also, if you can, it's probably better printed in Nylon or PC if your printer is set up for it, unfortunately mine isn't - yet. Designed to be used with 3M double sided foam tape from Bunnings (Aussie equivalent of Lowes/Home Depot). They're sold in 25mm /1 inch strips. Cut up two square pieces ((25mmx25mm) to attach to the ends of the chin mounts as shown in the picture. I've designed it so it can be attached high or low along the helmet's chin guard. I've attached it to the very bottom, as shown in the photos, as it suits my riding style. It does cover the front vent holes (see the gap in the photos) but doesn't completely seal them off. I've tested it on a 30+ degree day and didn't notice much difference. Be careful when sticking it on to the helmet as the tape is very sticky and easily attaches to the helmet at a wrong angle if not careful. Enjoy and show me how yours is mounted.