Bike Stand 75mm Vector 3

thingiverse

I tested this design with my older road bike and it's amazing! The best bike stand I've found on Thingiverse. But the problem with my racing road bike was that the Vector 3 was standing over the crank arm on the inside. So, I made some changes at the 75mm stand. Another issue was the wider crank arm of the Ultegra 6870, so this was changed too. In the original design, it fitted the Ultegra 6700. If you have the R8000 or any other crank and are having problems, I can make the change for you. The length is measured between the bottom and the lower end of the crank while the bike is leaning against a wall. I measured 70mm, but since that file doesn't exist, I used 75mm instead, and it works just as well! Because of some technical issues, you'll need to scale this file down to 10% in your slicer. Not much infill is needed; 10% should be enough. The fastest print will be laying on the back (you can see it in the picture). I'll add more photos soon.