Bike (recycled assembly project)

grabcad

Big Rim- I used the big rim for the wheels of the bicycle, I did two modifications to the Big Rim. The first mod was creating a revolve of an arch around the rim to mimic a tire, the second mod was an extrude cut on the inside of the rim to make the sprockets.Channel slot- I used the channel slot for the pedals, I mainly kept the channel slot the same. The only changes were extruding a circle and made a thread on the circle so it could screw into the pedal arm.Hitch Pivot- I used the hitch pivot as a support for the handle bars to be attached to, the only difference I made to it was cutting off the ends that stuck out above the circular cut extrudes.Trapezoid block- I used the trapezoid block to attached the hitch pivot to the steering fork, I got rid of the extrude cut to make it a whole piece, and rounded out the edges on the bottom.Plate- I used the plate as a design on the screws, I didn't modify it at all.Fork Spacer- I used the fork spacer as a mount for the seat to go in, I didn't make any modifications to it.NEW PARTSBike frame, spacers, steering ball, steering ball connector, handle bars, pedal crank arm, gears, chain pieces, and bike seat.