Bike Headtube Headlight Mount

prusaprinters

<p>I made this to mount a headlight to my bicycles headtube instead of the handlebars. I don't like the light to move all over as i steer. The bolt hole to mount the light on this is 8mm.The headtube on my bike is about 42mm wide. I left some room in there so that i could put some foam tape to prevent this from scratching the paint, but to also give it a little traction. The only thing that holds it on is a single zip tie. The headlight i have is probably on the bigger side of what you are going to be using with a bicycle, and this, and the single zip tie, seem to be holding up very well.</p> <p>I know enough about bikes to know that all headtubes are not the same size, but I imagine you can scale this as needed. Mine is a 29" mountain bike with a threadless fork. I made this for my bike specifically, but i thought i would post it here just in case someone else can make use of it.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>.32</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>40</p></div> <p><strong>Filament:</strong> 3d Solutech PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>supports shouldn't be needed. print in current orientation.</p></div> </p></p></p> Category: Hobby