Bike - Brake Cable to Shift Cable Clip - Flat Front

prusaprinters

A clip to hold 5mm brake housing and 4mm shift housing together on your bike to keep things nice and tidy and rattle-free.Flat front design solves the problem where cables may pull away from each other (see this design). Also, its a great place to put a logo! Print Settings:Material: PETG recommendedPerimeters: ≥3, should be solid perimetersSupports: not requiredOrientation: print vertically, see uploaded gcodeBrim: Optional if you have bed adhesion issues.  Use cable_clip_v3_easybrim.stl and “Outer Brim Only” option for easy post processing. Updates9/2/23 - added an easy brim modelI added model of v3 that should give a little bit better bed adhesion by making a full loop on the first print layer.  Additionally, adding a brim is much easier to post process now using “Outer brim only” option. cable_clip_v3_easybrim.stl 8/21/23 - added v3I needed to remove the v2 clips…and they were on there a little too well.  I ended up breaking the clips to get them off.redesigned to have single entrance that makes it easier to attach/remove without compromising the designs ability to prevent cables pulling apart from one another.recommending PETG only for the flexibility/toughness required.fixed stl orientation for v2 stladded a print file11/30/22 - added v2Increased internal diameter for 4mm cableoriginal model could be too tight on 4mm cables and could cause creep over timeIncreased wrap around cablescovering more of the cable makes it harder for cables to pull outDecreased the length to 14mmAdded .f3d for people to adjust for their own needs