Bike Bottle Holder

thingiverse

A bike bottle holder for your standard 0.5l PET bottle. The holder is design with harder use in mind and therefor not too thin. There are two different versions. One with slots at the side and one without them. Check the measurements to find out if your bottle and bike will fit. Measurements: - height: 129.5 mm - diameter of the hole: 69 mm - diameter of the frame: up to 33 mm - screws: M5 Print Settings: - Supports: yes - Raft: doesn't matter - Walls: 3 - Infill: at least 20% - Material: - PLA works - PETG or ABS/ASA might be even better About the slots: They make the print a bit lighter. But also a bit less sturdy. They can also increase the print time, as the supports that are needed if you choose the version with the slots on the side may take a bit longer to print. If you are interested in a different size, just leave me a message on Printables and will see if I find time to make it.