Bike

prusaprinters

<p>Supports are required for the rear frame.</p><p>You can see the video here:&nbsp;</p><figure class="media"><oembed url="https://www.youtube.com/watch?v=tLqkvyrPnc8"></oembed></figure><h3>Instructions</h3><p>1 - Fit the chain ring into the cranks and then snap the pedals.<br>2 - Mount the 2 parts of the frame with the cranks set in place. Use 2 screws for that (2mm screw - 5mm length).<br>3 - Mount the front wheel in fork with a screw (2mm - 15mm length)<br>4 - Fit the rear wheel in the rear frame. You will need to open it a little (be careful to not brake it). After that, fix the wheel with a screw (2mm - 20mm length)<br>5 -Place the saddle in place (glue it if you want)<br>6 - Insert the fork in the front frame and fix the handle bar with glue.<br>7 - You can use a rubber band or a piece of thin rope for the chain. Don't use a too stretchy rubber, or it will stretch a bit, even if your wheel is loose.</p><p>Insert it thru the rear frame opening, near the saddle, and slide it thru the clearance between the rear wheel and the frame (hollow part). It will lay right on the sprocket.<br>The two indentations on the hollow part will allow the 'chain' to pass through the frame. I've made this to shrink the frame sideways.</p><p>You can see the different hole sizes. So, insert the screws in the bigger ones.</p>