BigTreeTech TFT70 V3.0 Case

thingiverse

After printing the original model by phesketh01 I believe it to be for an ever so slightly different variation/version of the BTT TFT70. Creating a number of small defects that prevented my BTT TFT7 V3.0 from fitting into the case properly. After butchering the original print to work, some measurements followed by a quick-n-dirty hack job in TinkerCAD I got the job done. Now the final print looks decent unlike the butcher job. Things I changed: 1. The speaker was hitting the case before the screen would fully seat. So I created a small pit into the case to give clearance for the speaker. I did not make a hole all the way through. Doubt the case will muffle the speaker much but it is easy enough to drill a hole if desired. 1. The curves of the screen hole prevented the screen going into the hole without use of force at the corners. Made the screen hole a little bigger and removed the curves at the same time. 1. Curves for the internal structures on the dial side were preventing the PCB from fully seating. Chopped off the curves where they went above being flush with the screw holes. 1. Hole for the reset button was slightly to small for the base of the button and not centered on the button either. Centered the hole and made it larger at the base. 1. Made the hole for the dial larger. It fit but it was tight plus the LEDs were blocked. They can shine through now. 1. Screen screw holes were slightly misaligned on both panels by 0.3mm preventing you from getting a screw all the way through. That's fixed now.