Bigtreetech TFT35 V3 Case

thingiverse

I made a strong case for the Bigtreetech TFT35 to fit seamlessly on the Anycubic Predator, but it should also fit perfectly on many other printers. The case holds securely with 4 powerful magnets that need to be glued into the holes in the corners. Specifically, these magnets must have a diameter of 8mm and a height of 3mm. However, there is one minor issue - the knob protrudes slightly too far. Fortunately, this does not pose a problem for me. If you're not satisfied with it, I created an alternative knob that should sit much closer to the case. You won't need to replace the entire front plate; simply install the new case over the original display hole. Link to magnets: https://www.amazon.com/Neodym-Magnet-8x3/dp/B0187JGP1I/ref=sr_1_5?__mk_en_US=%C3%85M%C3%85%C5%BD%C3%95%C3%91&keywords=magnets+8x3&qid=1568560242&s=gateway&sr=8-5