BigTreeTech TFT24 display case remix

thingiverse

Original display case from Kotvic looked great but did not fit my TFT24 and was too bulky for my needs. So I trimmed it to get better access to the display (front panel is now 1.6mm thick instead of 5mm), reworked port holes for a better fit and made over 100 small changes. Display part and backplate were done almost from scratch (original used as a template), mount was changed only a little (removed tiny gap between arch and base, prolonged it by 0.8mm to fit more tightly and made holes for screw caps). **Update** Deepened screw holes on front panel by 1mm for use with 16mm screws. Slightly moved knob hole and reset hole (by 0.25mm). Added knob washer. **If the washer does not screw very easily with very little force, do not force it! You could damage your board.** Either file it or print it again with incrementally higher negative "horizontal expansion" (in Cura). **Update v2** Mount v2 has larger cap holes (+0.5mm diameter) and is slightly longer (+0.1mm). Nut holes were too small, so I increased their size to fit M4 nut. I recommend printing with 0.12mm layer height in PLA.