Bigtreetech Smart Filament Detection Module Mount CR10 / Ender 3 for BMG Dual Drive Extruder

thingiverse

This is a remix of the original part from BigTreeTech https://github.com/bigtreetech/smart-filament-detection-module/tree/master/STL.\r\n\r\nThe electronics are taken directly from the original sensor housing.\r\n\r\nAfter installation, verify that filament runout distance is set correctly; if not, the printer will stop immediately after starting to print. Mine was initially set to 0mm, but updating firmware resolved the issue. To set the length to 7mm, use the following command: M412 D7.\r\n\r\nM412\r\necho: Filament runout ON\r\nFilament runout distance (mm): 7.00\r\n\r\nFor mounting the filament sensor to the extruder mount, you will need:\r\n4x M3 nuts\r\n4x M3 x 12mm screws\r\n4x M3 washers\r\n