Bigtreetech GTR V1.0 box

prusaprinters

Remixed version so it can fit Ender 3 models.Small estetic improvements ( i dont like chamfering, only when needed)All cables routed to come from bottom side of the case.Added 2 part cable bracket for easy cable instalation.Enlarged portion of the box so it can accomodate  a buck convertor or similar.Adjusted holes so it can fit bottom extrusion, without interfering Z axis movement even with USB cable attached.Modification of screw pillars, and added 2 more on the side, since the lid tends to warp when tightened only in 2 points.Angle bracket to be mounted and add more vertical support, since i didn not want to try my luck with metal screws under the GTR, i made guide pins and glued the bracket to the back, and a T-Nut to bottom extrusion. Holds with no issues.Cables best fit in holes (if you look on the bottom side from left to right)Motor cablesPower cablesExtruderDisplay cable goes also from the bottom side, in a little notch.All stock cables fit, but you will need to move LCD to the left side, or buy longer cable.Fan hole is centered above drivers, it fits 60mm fan.I did print already modified version, you can spot little differences, then later updated designe after i assembled the board and found some weak spots.