Big Pushbutton Base / Enclosure

Big Pushbutton Base / Enclosure

thingiverse

This is a base for Sparkfun's line of Big Dome Pushbuttons (https://www.sparkfun.com/products/9181). I printed this with ABS and the pushbutton snaps right into the top of the ring. There are several configurations you can print, including a basic base for the pushbutton or a ring with two built-in brackets for 8 ohm speakers and a base with a hole for a slide switch. The bottom is attached to the ring by two M3 screws: https://www.mcmaster.com/#catalog/124/3077/=1c12237. The slide switch attaches with hot glue from the inside. The entire switch, including attachable wings, should be no bigger than 20mm x 8mm and the actuator length should be 4mm or shorter. I used a switch I had on hand and can't recall where I purchased it. #### Audio Button Project For my project, I connected the big pushbutton to the Adafruit Audio FX board via a Push-button Power Switch breakout, two round 8 ohm speakers and three AAA batteries. Then suddenly I had a self-contained speaker box that plays an audio file when the button is pressed. * https://www.adafruit.com/product/2217 * https://www.adafruit.com/product/1400 * https://www.sparkfun.com/products/9151 * https://www.digikey.com/product-detail/en/mpd-memory-protection-devices/BC3AAAW/BC3AAAW-ND/863319 The only thing I would do differently is add a small Arduino, like an Adafruit Trinket, to send a kill signal to the Push-button Power Switch breakout after the audio has finished playing.

Download Model from thingiverse

With this file you will be able to print Big Pushbutton Base / Enclosure with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Big Pushbutton Base / Enclosure.