Big Potentiometer Knob

thingiverse

Customized version of http://www.thingiverse.com/thing:54024 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=54024 Instructions Using the following settings: Pointer2 is set to 1. Pointer1 is set at 1. The timer knob is not moved. A knurled surface is selected. The hole diameter is exactly six millimeters. The shaft diameter is also six millimeters. Shaft length is zero. Ten markings will be visible on the ring. No flatness in the hole is chosen. The knob height has been set at twenty units. The depth of the hole is ten units deep. Cap type two is selected for the end result. A notch in the shaft is not chosen by the user. The diameter of the knob is thirty millimeters. Ring width remains zero for this specific design. A screw hole diameter of three millimeters is preferred. The taper percentage has been adjusted to twenty.