"big einsy case" for mini rambo - mk2.5s - vmod expansion board

thingiverse

this is NOT a remix of toto99303's model, but I'm linking it as a remix so people see it. its actually a remix of this: https://www.prusaprinters.org/prints/31558-big-einsy-case. i only modified the case and lid, the cable clips are unchanged from Boogie's design (i will post them here for ease of access, but please give Boogie a like on prusaprinters.org for his design!) to use this you need to get new psu cables about 150-200mm longer i used 16ga wire (because this is longer than the Boogie's design to accommodate the expansion board, longer psu cables are required) i WOULD NOT EXTEND THE CABLES. BUY NEW CABLE! its cheap and its not worth the fire risk of a spliced power cable. there are 2 versions of the lid: option 1: "cable entry lid v3.stl" - should allow for stock x axis cable length (although not tested) if you use this use the "einsycase-cover-cableholder.stl" for the lid and "einsycase_extruder_cable_cover.stl" for the extruder cable hole. option 2: "normal lid v3.stl" - requires an extension to the x axis motor cable by 150mm-200mm, this is fine to splice if needed. if you use this use the files "einsycase_cable_cover_1.stl" and "einsycase_cable_cover_2.stl" both lids have hole spacing for a 40mm fan, you can place a fan in any location. mount with 4x m4 screw and nuts, and run the cable down and into the bottom of the case (possibly though the side hole if using option 1 lid, not confirmed) this will fit on mk2 frame and uses the mini rambo board it was designed with the mk2.5s and should work for the prusa i3 mk2 mk2s mk2.5 and mk2.5s printers, but i can only confirm it works with mk2.5s (since that's what i have) i printed in pla with a 0.4mm nozzle (because that what Boogie used in his, but petg should be fine.) suports on the "main_body.stl" (touching buildplate only) some sanding and filing may be needed for the extruder cable clips to slide smoothly (only took like 1-2 minutes with a file) for more information about the vmod expansion board look here (tl;dr it allows the install of tmc2208/2209 for stealthchop2 on the x and y, and possibly z axis if you get 2 boards): https://vmod.wordpress.com/prusa-mk2s-ext-driver-board-v2-3/