BIDER - Quadruped

thingiverse

This is specifically designed for laser cutting purposes only. To accomplish this project, you will need 3mm and 6mm MDF boards as well as one 8mm OD wooden dowel. Please refer to the provided photos for guidance on assembly. Double-sided Scotch tape is used to bond the servos and joint plates, as depicted in the images. For this project, a 9G EMAX servo was selected without any particular reason in mind, but its design proved to be beneficial; the wires exit the servo in a manner that allows for precise placement of the servo within the designated space. This eliminates the need to allocate additional space for wire routing and reduces the risk of damaging the servo during assembly. Cut the 8mm wooden dowel to approximately 10mm in length. It is acceptable if the resulting pieces are slightly longer than shorter, and some minor protrusion from the plate is unavoidable. Unfortunately, detailed instructions were not provided; please feel free to pose any questions you may have, and this guide will be updated accordingly. Thank you for your understanding!