Bicopter / Twincopter / Dualcopter

thingiverse

New design utilizes the default PID system, making it remarkably simple to pilot even execute flips with ease, significantly easier than navigating a singlecopter. (http://www.thingiverse.com/thing:1555053)https://www.youtube.com/watch?v=vbzvSiuaxHQhttps://www.youtube.com/watch?v=wKCxqi30l2o Print Settings: Rafts: No support is required Supports: None needed Resolution: 0.2mm precision printing Infill: 15% density for optimal results Notes: ABS material was used, with 0.2mm layer thickness, 15% infill, three shell layers, and three top/bottom layers. Post-Printing: BOM (Bill of Materials): M3x8 Nylon Threaded Spacers: 4 required M3x10 Nylon Threaded Spacers: 12 needed M3x17 Nylon Threaded Spacers: 4 required M3x25 Nylon Threaded Spacers: 4 required M2 Self Tapping Screws: 4 used Paper clips: 2 utilized Ez connectors: 4 connected Carbon Fiber Rods (2.5x70mm): 4 used Carbon Fiber Rods (2.5x110mm): 4 required Servos (25mm mounting): 2 used, each weighing 4.5g 12A ESC: 2 units employed Flight Controller (FC) support: Any BICOPTER FC will work, but Multiwii is recommended, with a 30.5mm mounting requirement Motors (2204 2300kv): 2 used Battery (3S 1300~3S2200mah): 1 unit connected 5045 components: 2 utilized Receiver (RX): 1 unit installed How I Designed This: This design was created to be straightforward and simple, with easy printability, assembly, repair, and flying capabilities, ensuring safety above all.