Bibo wire grommet

thingiverse

I'm installing Bibo wire grommets for the three inside holes - XY stepper wires, Heater and Z stepper, and filament out switch. These grommets also include a filler for the front hole on the left. Each grommet is cut so they can be installed without removing or unplugging the wires. Currently in progress, I chose not to complete the heater wire on bed because it didn't seem like it would make a difference. The code remains there if you'd like to try it (it looked like it could cause other issues). The SCAD file is included and should be customizer ready. With this file, the grommets can be adjusted for different printers. Print settings are .2, infill doesn't matter, and no supports are needed.