BIBO 2 Touch Snap On 5015 Blower Mount

thingiverse

SUGGESTED USAGE: For stock printer: 2x BIBO_Snap_on_5015_duct_orig_fans_V8b.stl (or BIBO_Fan_Mount_V8C.stl) 1x BIBO_Snap_on_5015_duct_ultraslim_with_support_V8c.stl for rear blower 1x BIBO_Snap_on_5015_duct_orig_fans_bearing_covers_thin_V8b.stl for front blower If you remove the bearing covers, you can use BIBO_Snap_on_5015_duct_ultraslim_with_support_V8c.stl for the front blower. If you remove the outer spacers and fan guards, you can use BIBO_Snap_on_5015_duct_ultraslim_with_support_V8b.stl for the rear blower. File notes: BIBO_Fan_Mount_V8.STL -- the mount base that attaches to the BIBO carriage plate. BIBO_Fan_Mount_V8B.STL -- updated with larger holes for throat mount screws. BIBO_Snap_on_5015_duct_ultraslim_V8.STL -- As thin as possible version -- blower touching edge of carriage. Will need to print with support for the crossbar. Will clear the Z bearing when used as rear duct. BIBO_Latching_Fan_Mount_V8C.STL, BIBO_Latching_Fan_Mount_double_V8C.STL -- Latching versions of mounting blocks, each prints in two pieces. File notes: BIBO_Snap_on_5015_duct_orig_fans_bearing_covers_offsetV8.stl -- Version to fit with original fans and bearing covers. Sticks out 2mm farther than the rest. BIBO_Fan_Mount_double_V8.STL -- Double version base for future development. BIBO_Snap_on_5015_duct_orig_fans_bearing_covers_thin_V8c_plus1mm.stl -- super thin version to fit with original fans and bearing covers, duct 1mm higher from bed. Comments, suggestions, and requests welcome.