Bias Tape Folder (1", 1.5", 2", and 2.5" versions) with notches for pins

thingiverse

Here is the rewritten text. Remake of "4cm Bias Tape Maker" by GazdaTony <https://www.thingiverse.com/thing:4230339> was created to have notches on the edges for easier pinning to an ironing board. Testing proved it worked well, but the 2.5" design is a bit tricky, requiring further work and testing. Little tabs were added to connect bottom notches for secure printing, which would be cut off after printing. These files are marked with "Tabs" in their names. A strip of fabric should be inserted into the loading end, clipped into a point, then pulled through and ironed as you go. A video demonstrating this process can be found at https://www.youtube.com/watch?v=ZbVi11p5iEs. It was printed with 10% infill using PLA, but it would likely work with most infills.