Bezel/Case for PiSugar and 5" DSI LCD

thingiverse

Bezel to mount a 5" LCD on top of a PiSugar case. Sized for a PiSugar S Plus with the 5000mAh battery and similar footprint to a Pi 4B. Print the PiSugar case but skip the top and print these parts instead. LCD mount is sized for the Waveshare 5" DSI LCD. Mount the LCD using standoffs that raise it above the PiSugar case then the bottom of the LCD case fits around the PiSugar case and covers the gap. Flip Bottom-PiSugar over before printing it! I also included a regular bottom if you want the LCD in a separate case. I don't know if the tabs will work to hold the top to the bottom because I snapped them off and glued the top to the bottom. The LCD mounts on top of the Pi (instead of the bottom) so the cable that comes with the Waveshare DSI LCD will need a 180 degree twist. The cable can handle the twist but be careful. The box and slider make a little drawer that's sized to fit an adapter for the HDMI port and other little pieces you might want to keep with the device (like MicroSD cards). You can glue the slider as shown in the picture to make it a little drawer under the LCD. The flip stand is cheesy and needs to be angled properly to actually be a stand. Print two pivots then glue them to the bottom after putting rubber feet on (or use a better stand). I found the easiest way to assemble this is to first put the Pi and the PiSugar together using one screw from the Pi side into the PiSugar at the corner where the power connection is. Then mount three standoffs to the LCD and screw the Pi/PiSugar assembly to the LCD from bottom. It's not completely solid that way but it's stable enough for normal use.