Beyblade Dual Launcher "Paulman"

prusaprinters

<p>This Beyblade Launcher is designed to be as reliable as possible.</p><p>It uses bearings and magnets for the stoper mechanic to reduce friction and down wear.</p><p>You need 2x 608RS Bearings and 2x 8x3mm(or 2mm) Magnets<br>(One 2x10mm Screw for the spinner to be replaceable)</p><p>Added the .f3d of the outer Spinner so you can change it for other series than Beyblade Burst.</p><p>The spinner is the one part that can break.<br>Spinner in 2 parts so, no support needed and easy to replace.<br>(Use a Screw instead of glue)</p><p>I use the Ripper by WuffyUnikitty (Thingiverse) , its perfect as it is :-)<br>The launcher is designed after his model. Tried to improve it while rebuilding it from ground.</p><p>Have Fun</p><p>&nbsp;</p><p><strong>Assambly&nbsp;</strong></p><p>For assambly see the drawing.</p><p>The Spacer goes under the Gear.</p><p>Check that the Magnets in the Flapper and Bottom repel each other.</p><p>You need to glue the Axis Bottom Part and the Spinner Inside Ring together when not using use a small screw , i use a 2x10mm Screw.</p><p>For Top and Bottom use 4x M3 to screw together, various lengths usable.<br>(When using glue screw them tight after glue tryed)</p><p>Tipp: Use the Ripper to hold the Flapper for assambly.</p><p>If you feel that the rotation is not perfectly round : use pressure on the bearings to get them parallel.<br>With the screw you can adjust the resistance and with the 2 Part spinner you can adjust inperfect prints by moving the outside ring up and down on a side ,for perfect rotation.</p>