Better CR-10 V2/V3 Glass Bed Clamps

thingiverse

This is a set of clamps designed to replace the hinged metal glass clips included with the Creality CR-10 V2/V3. These clamps will hold your glass in place with the added benefit of not obstructing **any** of the print surface. Never worry about bumping your nozzle again! The clamp bases mount using the original Creality hardware. You only need to add **four M2.5 x 10 nuts and screws**. I recently purchased TH3D Studio's excellent ezflex2 system, but all of the installation instructions I found showed folks installing the magnetic print base directly onto the heated metal bed. Knowing Creality's rough history with making things flat and level, I didn't want to trust that, so I cut a new piece of glass to install it on and then realized that the bed clips on the printer wouldn't work, as they're too snug. Thus, this project was born. There is a "back clamp" for the rear edge of the print surface and a "corner clamp" for the front corners. Each clamp has a base that attaches to the print bed and the top part that attaches with the M2.5 screws.