Betrayal at the House on the Hill Print in Place Game Pad Holder

cults3d

I rebuilt it in Fusion360, but got the idea from this post. Its very similar, but can be print in 1 piece. Supports are needed only for the arms. I did infill at 100% since its very thin anyway. At lower infill I was having problems under the arms not printing a top layer of shell. Took many printing attempts adjusting flow rate and horizontal expansion so that it would have some friction. I recommend printing in PETG since its softer and gives good friction, and isn't just scraping like with PLA from my experience (if you get better results let me know). I stopped a couple of times after the first couple of layers if the dials were touching the bottom of the pad. I sliced with CURA 3.5.1 and came out well.