Betrayal at Baldur's Gate Character Tile Tracker

Betrayal at Baldur's Gate Character Tile Tracker

thingiverse

You will also need: - 8 3x2mm circular magnets (Unaffiliated link: https://www.amazon.com/dp/B0B5GGSK3F) - 8 46x1mm metal rods - some craft glue - pliers (optional, but useful for snapping the magnets into place) I liked the designs I found for the Player Card holders, but none of them allowed me to slide the arrow back and forth (there is a "Windowed Claw" version I saw, but that's more rotational than sliding) so I made my own :) This will also work for Betrayal at House on the Hill since you aren't limited in the placement of the arrow, though I think the arrow length is a tad short in which case you can use the ones in https://www.thingiverse.com/thing:5828014 which this is remixed from Fair warning: it is a little bit of manual labor post-printing, but I personally liked the results so I hope some of you will enjoy it as well. Directions: Print 4x of the `Border Piece` and 4x `Magnetic Arrow` for every 1 `Border` as shown in the pictures. For the `Magnetic Arrow`s, the magnets on the underside are friction fit but if you find yours to be too loose, a small dab of craft glue will hold them in place. A set of pliers helped me immensely in snapping the magnets into place. Feel free to make the `Border Piece` a little longer (1-2mm at most) if you find yours has a gap. I intentionally left a tiny gap because my printer tends to have some pretty bad elephant's feet depending on the print resolution, but they should fit fine without too much hassle. For each `Border Piece`, I bent some paperclips into straight (or as straight as I could get it) pieces and cut them into 46mm long rods that I then slid into the holes and glued into place. You could get away without glueing them, but I found that the glue helps to keep them near the surface of the print and there is less rattling around, but ymmv if you're not jerry-rigging some metal rods out of paper clips. Lastly, apply glue to the bottom (the side where you insert the rods) of the `Border Piece`s before putting them in their respective places on the `Border`.

Download Model from thingiverse

With this file you will be able to print Betrayal at Baldur's Gate Character Tile Tracker with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Betrayal at Baldur's Gate Character Tile Tracker.