betafpv lite remote 2 finger stops

thingiverse

Resize in slicer to 20mm on the longest side or it will be to small. This is to stop fingers from blocking the betafpv lite radio antenna. It's a comfortable enough rest you can use it anywhere you want to rest a finger in a specific placenta but the bottom is flat so use double sided foam tape for the curved surfaces. 20 to 22mm works but it is a quick enough print I'd measure the width of your finger you're going to rest on it and add a few mm. Test it out and add minus some to get it perfect if you need. So lets say you have 16mm finger tips like I do I'd size it to 18 or 19 mm. my print came to 22mm and its got some wiggle room. Use your best settings for your roll of choice should work, I did no supports and had no problems.