BetaFPV ExpressLRS 2.4G folding TPU holders

thingiverse

These folding TPU holders for BetaFPV's ExpressLRS 2.4ghz receiver have been designed to be reusable and easily printable. There are 4 different versions: Plain (use tape or something to hold it down) 20x20mm mount 25x25mm mount 30x30mm mount Print in TPU at 0.2mm layer height, 3 perimeters, 100% infill, no support. I also included the original model I made of the 2.4G RX which I used to make the folding holders, in case anyone wants to use it to model their own holder. Installing: After printing, without the receiver in, fold it over and close it shut then open it back up to understand how it works and the force needed to close & open it, 'peeling' it open is how I open them up, it helps stretch the TPU enough to take it off the over the pins. Then carefully press the receiver into the bottom half of the holder (the side with the pin sticking up), make sure it's sat in properly (see the photos) and then fold the top over. Best to put the RX in the holder before installing it in your craft. Direct downloads from my website: http://www.haku.co.uk/3D/BetaFPV_ELRS_2.4G_plain_holder.stl http://www.haku.co.uk/3D/BetaFPV_ELRS_2.4G_20x20_holder.stl http://www.haku.co.uk/3D/BetaFPV_ELRS_2.4G_25x25_holder.stl http://www.haku.co.uk/3D/BetaFPV_ELRS_2.4G_30x30_holder.stl http://www.haku.co.uk/3D/BetaFPV_ELRS_2.4G_RX.stl You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit. Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive