BetaFpv 75x Pusher Parts / Pieces for 75x Pusher

cults3d

rx antenna support , Landing feet / FC protection , canopy / vtx antenna support You will need : original screws and bolts, a 75x of course ( I have the 3s version which is not limited by the few grams of tpu in + ) of 2 M2x4 or 5 mm There is the canopy for cameras style Eos 2 or equivalent in 14x14 Start by completely dismantling your kwad, you will have to turn the fc over anyway. (Design only adapted to 75x frames, which are equipped with leds. ) Rotate your drone 180° on the Yaw so that the rear led holder is in front. Install the canopy by inserting the bottom part of it into the LED support. Then attach the brackets to the outer holes of each motor. You will have to tilt these slightly to screw, because without this your canopy would constantly come out of the housing for LEDs. If you need to adapt other parts, don't hesitate to write me to realize this ;) Good flights to all ! Support antennas rx, Landing feet / FC protection, canopy / Vtx antenna maintenance You'll need: of the original screws, d a 75x of course (J have the 3s version which is not limited by the few grams of tpu in ) 2 M2x4 or 5 mm There is the canopy for cameras style Eos 2 or equivalent in 14x14 Start by completely disassembling your kwad, you're going to have to turn the fc over there afterwards. (Design only suitable for 75x frames, which are equipped with LED location.) Rotate your 180-degree drone on the Yaw so that the back LED support is in front of it. Install the canopy by inserting the lower part of it into the LED support. Then attach the fastening legs to the outer holes of each engine. You will have to tilt these slightly to screw, because without it your canopy would constantly come out of the accommodation for LEDs. If you need to adapt other pieces, do not hesitate to write to realize it ;) Good flights to all!