BetaFPV 65X 300mah 2s Turnigy Nanotech battery holder

thingiverse

I remixed this from the Mobula7 mount by Thump2010 to allow it to fit securely on the 65x frame and still have a receiver slot. Weighs 1.27g after removing all supporting material. I'm not very skilled with 3D modeling, so if you have any suggestions I can try to modify or would like to improve on it yourself, feel free. Installation: Cut off the clip part of the print in the center as shown in the first and third pictures. You can cut straight down the middle but then you'll need to lift up the stack to install. Insert the longer side first and then the shorter side. If you want to, you can glue the two halves back together, but it feels very secure without any glue because the ESC holds the clip flat. Tips: You'll want to print it vertically as shown in the pictures for strength so that layers go through both the clip and battery holder. I printed in TPU at 25% infill with two walls (this allowed the clip part to be hollow using Simplify3D but it's still plenty strong). I also had to set "internal thin wall type" under advanced to "allow single extrusion fill" for the battery holder part to print how I wanted it to. I set both top and bottom solid layers to 27 so the part of the clip that attaches to the battery holder is secure (27 at .12mm layer height, if you use another layer height this will be different). Use supporting material as shown in the pictures.