Beta95x V2 Pusher DJI Caddx Vista Antenna Mount (NEW BETAFPV STYLE)

thingiverse

A new mount for the Caddx Vista for the V2 pusher from BetaFPV. Use existing bolts that hold the Caddx Vista to the top plate. Make sure vista antenna connection is facing forward (towards camera), the antenna will be routeted directly vertical then 90 over the top of the vista to the TOU mount. Use 1 small zip tie around antenna to secure it just below top of antenna. The only issue (but non issue to me) is you need the ant (@ U.fl connector) facing forward and then the antenna comes across the top of the vista which when tightened gets pressed between carbon and vista (I haven’t had any issues) but what you can do if it bothers you is use a small file or Dremel and make a tiny notch on the bottom of the top plate on the edge back (basically where it would touch the vista). A small channel for the ant on the underside on top plate, it’s very easy takes 5 min with a file and your just barely taking 1mm out off the bottom. As long as you don’t overtighten (which people tend to do) the vista it’s fine without doing above technique, but you people who like to strip bolts, and max out the torque by over tightening just be careful :-p Plus overtightening TPU isn’t smart anyways! * I’m making some slight modifications to the length of TPU where you secure it with a zip tie and thickening the outside diameter a slight bit, also making the two holes closer to the front of quad that fasten down the mount more closely follow the contour of the carbon plate, besides that nothing else will change and no functional difference.