Benriner Super Slicer 95c Mandolin Blade Protector

thingiverse

Surprised this slicer didn't come with some sort of blade protector (or finger protector) for storage, so I designed one. It uses either 1 or 2 stacked 18x3mm neodymium magnets to hold it in place, start with 1 and add another if you think you need it. I crazy-glued my magnets because they were pulling so hard I was afraid they'd pull through the bottom of the part. I've since added a little more material under them so hopefully it's not an issue, but something to keep in mind. It only contacts the ends of the blade to prevent damaging the working part of the edge. It works great but I'm going to see if I can make it look a little nicer at some point.