BennyModz Nerf Longshot Dartgate

thingiverse

Lost your dart gate? Don't worry! Just print this and everything will be fine! READ THIS BEFORE PRINTING This dart gate is designed specifically for use with homemade breeches, allowing a 9/16 inch brass sleeve to fit over it comfortably. However, if you find the brass too tight, simply heat it up and slide it into place. To ensure a proper fit, some shell modification will be required, as evident from the accompanying picture. Once modified, the dart gate should sit flush and aligned within the shell. When printing, refrain from rotating this model on your slicer; instead, leave it as is and add support that touches the build plate. Be sure to avoid placing any supports inside the dart gate, as this may cause difficulties when removing the supports or attempting to sleeve the brass in.