Behringer UMC22 mount

prusaprinters

Printed in 2 parts (left and right side). I used PETG, use whatever filament you want. Parts are oriented for printing, I printed it with 0.3mm nozzle (because I'm insane), you can use whatever you want, preferably 0.4 or 0.6mm. Use a minimum of 4 perimeters on 0.3mm nozzle or 3 on 0.6 and as high of an infill as you feel comfortable, but 20-25% should be enough, use a brim if you're not sure about bed adhesion. After you're done printing, clean up the parts, and mount them wherever you want (holes for screws are 1.5mm, but you can use any countersink screws with a head diameter up to 7mm.) Mount both parts with one screw so it can move, mark the other holes, make sure the interface fits (should just snap into place) and if it does, predrill the other holes and mount it permanently. When you're done, the interface should latch into place, and if you need to remove it, open the clips gently with both hands and push on the interface from behind so it slides out.  Fusion files are provided if you need to edit anything, or just ask in the comments, and I can edit the files for you. Also, If you have any suggestions on how I can improve the design, feel free to let me know.