Beer BIT, Chill you beer in 10 easy steps!!

thingiverse

People love drinking beer straight from the bottle, but did you know you can upgrade that experience? Here's a simple 3D print modification to make it happen! Dana GUR's sketch brings this project to life. To turn any ordinary bottle into an amazing DIY experience, follow these steps: 1. Start with a cold warm glass of beer - it doesn't have to be a specific type! 2. Take the stl design and duplicate it. 3. Superglue both copies together perfectly without using any clamps or tapes, but don't overdo it! Just add the amount needed to hold the pieces securely. The key is applying gentle yet firm pressure - apply just enough force for each layer. Make sure they adhere smoothly for a sleek look! 4. Now insert 7mm metal into one of the small holes and carefully tighten until you hear an audible "click" or until the bottle starts getting too difficult to handle at which point just back off about half an inch – that's roughly the point when friction begins to cause significant difficulty turning it with ordinary hand strength alone so simply screw another layer down further along the side before moving up. 5. The other part of this modification involves plugging your beer cap into place over 30mm hole. When done correctly there should be minimal visible sign if done right.