Bed Wire management (best with automotive wire loom)

myminifactory

Minor tweak and some refinements to my bed wire management clamp (works best with 3/8" automotive wire loom) - primarily added an angle upward slightly for more even flex and modified the mount to wrap around the loom instead of inside, giving wires extra room. Mounting/screw hole isn't included in the design; I've discovered that there are simply too many different printers with varying plates and wiring run preferences to accommodate all of them. It's much simpler to hold it in your preferred location for your printer, use a lighter to gently heat up the end of the screw, and then push it through the plastic. Then install.