Bed Probe Holder 18mm

thingiverse

Holder for an 18mm Bed-Probe attachment. It screws between the hotend mount and the x-carriage on a standard bowden setup. Three millimeter screw holes are provided at 25 millimeters and 30 millimeters apart. You can expect to lose about 30 millimeters of print space on the X-axis due to its design. A redesign was done on February 21st, 2017: The backplate became thicker, and the mounting hole was moved for longer hotends on extended files. This model was created using Creo Elements Express software. Print Settings are as follows: Printer settings were set at P3Steel. Raft settings were left off. Support settings were also left off. Resolution was set to 0.3 millimeters. Infill density was set at 100 percent.