Bed Leveling Knob (for AdimLab/Prusa/CR10S & clones)

thingiverse

This upgrades the small buttons on the Adimlab (identical to Prusa, CR-10s, etc). Employ a robust PLA or ABS filament (I utilized carbon fiber PLA, incredibly strong and simpler to print). Utilize 100% infill. I traveled to the hardware store and purchased four 5mm x 10mm socket head cap screws (these are hollow fasteners with threads on both the exterior and interior, utilizing an Allen wrench to secure them in place) along with four matching screws that fit my print bed, approximately 40mm long. Drill a hole at the center with a diameter slightly smaller than the socket head cap screws, and apply some epoxy to the threads and screw into place. It's beneficial to use a drill press for the holes. The size of these new buttons is significantly easier to manipulate when leveling your bed.