Bed Leveling Knob (for AdimLab/Prusa/CR10S & clones)

cults3d

This replaces the tiny knobs on the Adimlab (clone of Prusa, CR-10s, etc). Use a strong PLA or ABS (I used carbon fiber PLA, very strong and easier to print). Use 100% infill. I went to the hardware store and bought four 5mm x 10mm set screws (these are hollow screws with threads on the outside and inside, using a hex wrench to screw them in place) along with four matching screws that fit my print bed, about 40mm long. Drill a hole in the center with a diameter slightly smaller than the set screws, and apply some epoxy to the threads and screw in place. Helps to use a drill press for the holes. The size of these new knobs are much easer to manipulate when leveling your bed :)