Bed Leveler Upgrade - Monoprice Mini Select

thingiverse

So there you are, justly proud of your hot-end replacement only to notice that the bed level sensor is just a few short millimeters off-the-mark...Tempted to simply re-adjust the print nozzle, you realize that adding gaps in the plummimbing is probably why you had to replace the locus in the first place - why not simply move the sensor up or down, instead?That is what worked for me.Notes:Sled design: "Top" slides on tightly - trial fit before final assembly - push hard?Use original screws (M2.5) on "Btm"Use "what works" (M2 - M3) on "Top"Eye hole on "Top" is freestyle. I used an M3Bottom sled 1mm recess accommodates oversized "Top" screws p.s. If you've only one 3D printer, then you'd better print one of these sooner, rather than later. :-)Happy Hacking!