Bed level probe for Anycubic Kossel

thingiverse

I designed this after seeing the Alien Z Probe http://www.thingiverse.com/thing:820260. The probe sticks too far off the back of the effector, making it run into my z-axis belt. Not useful for me, but I think the design was good in thought. Perhaps someone else can make this work for them. To assemble you need: 2 hex nuts, which I believe are M4. 1 washer, again not sure of the size. 1 smooth rod bent at 90 degrees that fits cleanly through the hole in the nuts and the washer. 1 small screw. 2 lengths of wire. 1 connector for the 2 wires. I apologize for the lack of sizes. All parts used were salvaged from various printers, and I built to suit the parts that I had on hand.